mini gps shield GPS-14030 description: ? the ? sparkfun ? mini ? gps ? shield ? equips ? your ? arduino ? mini ? with ? access ? to ? a ? gps ? module, ? sd ? memory ? card ? socket ? and ? all ? of ? the ? other ? peripherals ? you?ll ? need ? to ? turn ? your ? arduino ? into ? a ? position \ tracking, ? speed \ monitoring, ? altitude \ observing ? wonder ? logger. ? the ? shield ? is ? based ? around ? the ? gp \ 735 ? gps ? module, ? a ? 56 \ channel ? gps ? receiver ? featuring ? a ? ublox ? 7th ? generation ? chip ? set ? and ? an ? up ? to ? 10hz ? update ? rate. ? the ? board ? also ? uses ? a ? level ? shifter, ? so ? there?s ? no ? need ? to ? worry ? about ? the ? logic ? voltage ? of ? your ? arduino ? mini. the ? mini ? gps ? shield ? is ? a ? mini ? version ? of ? our ? gps ? logger ? shield. ? while ? the ? gps ? logger ? shield ? was ? designed ? to ? work ? with ? the ? arduino ? redboard, ? the ? mini ? gps ? shield ? was ? designed ? to ? work ? with ? the ? arduino ? mini/micro ? boards. the shield comes with a 6-pin jst connector to connect the gp-735 module. if you already have a gps module, the jst pins are broken out and labeled to allow you to use just about any gps module that works down to 3.3v. the mini gps shield will work with any of our arduino mini boards. the board uses 3.3v logic; however, the logic level converter on the shield allows you to use 5v boards just as easily. the mini boards have symmetrical pins, which means it?s very easy to plug the shield in the wrong way. plugging the shield in backward won?t damage either board, but it is something that could be easy to overlook. make sure to check out the hookup guide below for proper installation instructions. features: supports gp-735 with pins broken out to support most 3.3v tolerant gps modules supports backup battery options usd memory card socket works with any arduino mini board (3.3v or 5v) uart switch controls serial communications configurable led to show gps fix sparkfun ? electronics ? ?
|